Note: After the configuration, you need to click on the web interface or use the command “ copy running-config startup-config” in the CLI to save the configuration, otherwise the switch will lose the configuration after it is powered off.There is a lot of applications using this. Enter 0.0.0.0 as the Destination and Subnet Mask, and enter the IP address of the Next Hop (Default Gateway). Go to 元 FEATURES > Static Routing > IPv4 Static Routing and click to load the following page. But we can manually configure a default route for the switch, and the effects are the same. On the Managed Switch, we cannot directly set the default gateway as we do on the PC or Smart switches. Go to SYSTEM > System Info > System IP page, specify the Default Gateway as 172.31.48.1, and click Apply.įor TP-Link Managed Switches (T1600G and T2600G series switches) TP-Link Smart switches do not support IP routing, and we just need to designate the default gateway. In this case, we need to set the router as the default gateway of the switch.įor TP-Link Smart Switches (T1500 and T1500G series switches) We still assume a network environment as the following picture shows, the switch needs to access the internet through the router. How to Configure the Default Gateway for TP-Link Smart and Managed Switches?
This default route means, the PC will send all the packets that go to the internet to the default gateway (172.31.48.1). The destination and subnet mask are both the fixed value 0.0.0.0, which means arbitrary destination IP addresses that are not matched by other route entries.įor example, as the following picture shows, the PC needs to access the internet through the router, so we can configure 172.31.48.1 as the default gateway of the PC.Īfter finishing the default gateway setting, the PC will generate a default route automatically. Then the default gateway will forward the packets to the destination.Ī default route consists of three parts: Destination, Subnet Mask and Next Hop (Gateway). Therefore, a default route can solve this problem: if no route to the destination is specified, the device will send the packets to a specific device, that is, the default gateway. The default route is a special type of static route, which specifies a path that the device should use if the destination address is not included in any other routes. Before configuring the default gateway, we need to have a general idea of default route.
0 kommentar(er)
